User manual

PROGRAMMING Menu
48
SR2MAN01 11/2007
Entering
Parameters on
Creation of the
Block
Parameters are entered in the same way, whatever the parameters screen:
Modifying the
Parameters of
Existing Blocks
To modify the parameters of an existing element, simply:
Step Action
1 Enter the desired automation function: Step 1 of the element entry (see Method for
Entering a Contact or Coil, p. 43) procedure.
When the function has parameters, Param appears in the contextual menu (when the
Shift key is pressed).
Illustration:
2
Press and hold down the Shift key and press on Param (key ).
Result: The function’s parameter screen appears.
3
Use the navigation keys to move to the cursor over the modifiable parameters: .
4 Modify the value of the parameter using the + and - keys, holding down Shift.
5
Confirm the modifications by pressing Menu/OK , which will open the confirmation window.
Confirm again by pressing the Menu/OK key to save.
Menu / OK
ins. - Param+Del.
Step Action
1 Use the navigation keys to move the cursor over the element to modify: step 1 of the
element entry (see Method for Entering a Contact or Coil, p. 43) procedure.
2
At the same time, hold down Shift and the Param key to open the parameter window.
3 Carry out steps 3 to 5 above.