User's Manual

C-Bus™ RF Wireless Key Fob and Visor Remote 63249-420-342A1

Instruction Bulletin 06/2010

PROGRAMMING THE KEY FOB

Follow the guidelines below to make the Key Fob functional.

 Program C-Bus Wireless units to recognize the key fob's

buttons.

 Program the key fob, wall units, and plug adapter units using

learn mode.

Learn mode is activated on the remote by removing the back cover

(see the "Installing the Batteries" section to remove the back cover),

and sliding the switch down to the Learn position. Refer to the steps

below to activate learn mode and to program the key fob.

Use the following procedure to assign a button on the key fob to a

button on a C-Bus Wireless wall unit or plug adapter unit:

NOTE: Assigning a button on the key fob to a button on a C-Bus

Wireless unit does not unlearn previous assignments to other units.

To do this, follow the instructions in the "Clearing Remote

Assignments" section.

1. Set the key fob to learn mode by sliding the switch across to

the Learn position.

2. Replace the back cover.

3. On the wall unit, press the Learn button to activate learn mode.

4. On the key fob, press the button you want to assign.

5. Quickly press the button on the wall unit you want the key fob

to control (within 30 seconds of pressing the remote button).

NOTE: All units on the network will enter Learn mode at this

time.

6. Repeat steps 4 and 5 to program additional buttons.

7. When you have finished programming the key fob buttons,

press the learn button on the wall unit to exit learn mode.

8. Remove the back cover on the key fob, slide the learn mode

switch on the back to the Use position, then replace the back

cover.