User's Manual

63249-420-342A1 C-Bus™ RF Wireless Key Fob and Visor Remote

06/2010 Instruction Bulletin

PROGRAMMING THE VISOR REMOTE

Follow the guidelines below to make the Visor Remote functional.

 Program C-Bus Wireless units to recognize the visor remote's

buttons.

 Program the visor remote, wall units, and plug adapter units

using learn mode.

Learn mode is activated on the remote by removing the back cover

(see the "Installing the Batteries" section to remove the back cover),

and sliding the switch down to the Learn position. Refer to the steps

below to activate learn mode and to program the visor remote.

Use the following procedure to assign a button on the visor remote

to a button on a C-Bus Wireless wall unit or plug adapter unit:

NOTE: Assigning a button on the visor remote to a button on a

C-Bus Wireless unit does not unlearn previous assignments to

other units. To do this, follow the instructions in the "Clearing

Remote Assignments" section.

1. Set the visor remote to learn mode by sliding the switch across

to the Learn position.

2. Replace the back cover.

3. On the wall unit, press the Learn button to activate learn mode.

4. On the visor remote, press the button you want to assign.

5. Quickly press the button on the wall unit you want the visor

remote to control (within 30 seconds of pressing the remote

button).

NOTE: All units on the network will enter Learn mode at this

time.

6. Repeat steps 4 and 5 to program additional buttons.

7. When you have finished programming the visor remote buttons,

press the learn button on the wall unit to exit learn mode.

8. Remove the back cover on the visor remote, slide the learn

mode switch on the back to the Use position, then replace the

back cover.