Network Management Teleservice Card (66124) ETH ERN PHON E ET SENS OR/R S 485 Installation manual ACT RESE T 100M ( Sett ings ) 6612 4 3402231500/AC CD 990-3402231500AC UPS D ata
INTRODUCTION OVERVIEW 000623001C07 000623001C07 The Network Management Teleservice Card (66124) is recommended for central UPSs protecting entire networks or for UPS units backing up critical loads.
INSTALLATION Your network is not equipped with a BOOTP/DHCP server The Network Management Teleservice Card (66124) can be hotplugged on MGETM GalaxyTM 7000 UPSs. It is not necessary to shutdown the UPS, disconnect the load or restart the UPS. ◗ A. Remove the plastic cover of the Minislot. ◗ B. Note the MAC address of the card before inserting it. ◗ C. Connect the PHONE cable. ◗ D. Connect the ETHERNET cable (network already connected). ◗ E. Insert and secure the card with the screws.
SENSOR CONNECTION (option) The Environment sensor is a Network Management Teleservice Card option. The sensor remotely monitors the UPS environment by regularly measuring the temperature and humidity, and checking the states of two external contacts. It can also send alarms (e-mail, SNMP trap) tripped by pre-set thresholds. Connection is made via the Service port (Settings/Sensor) on the Network Management Teleservice Card. The sensor is detected automatically.