InsightFacility Manual
Table Of Contents
- Safety Information
- Audience
- About
- Overview
- Installation
- Getting Started
- Configuring Devices
- Monitoring
- Troubleshooting
- Specifications
- Installing the InsightFacility Security Certificate
Configuring the InsightFacility
To complete InsightFacility setup, you must successfully complete the procedures in
Installation on page 22. Make sure the InsightFacility is connected, the Power LED is on,
and the Event LED is off. Your Xanbus devices should still be in standby mode.
When you initially log in to the web user interface, most of the setup information appears
automatically with their default values. Some information must be changed (such as
passwords), some information can be modified as needed, and some information can
only be modified by a qualified IT professional.
The following items are part of the InsightFacility configuration process:
Primary
1. Log in - see "Logging in to the InsightFacility Web Application" on the next page
2. Change the password - see "Changing the Password" on page39
3. Set plant site information - see "Plant Setup" on page41
4. Set the system time - see "Changing the Time" on page42
Optional/Occasional
1. Configure general device settings - see "Changing Device Settings" on page54
2. Upgrade the device firmware - see "Upgrading Firmware" on page46
Getting Started InsightFacility Owner's Guide
990-91411A 36