InsightFacility Manual

Cloud Settings
To use InsightCloud for remote monitoring and configuration, you must configure the
Cloud connection for your InsightFacility. The Cloud settings screen can be used to
check your Cloud connectivity.
To configure the Cloud connection for your InsightFacility:
1. Go to Setup > Network > Cloud settings.
2. Beside “Cloud enable”, select the Enable radio button.
3. If you are setting up the InsightFacility on your home network, a proxy is likely not
required. However, if you are using a corporate, or other externally managed network,
then proxy settings may be required. To use proxy settings:
a. Enter the proxy URL and port number.
b. If required, enter the proxy username and password.
c. Set “Proxy enable” to Enable.
4. Click Apply.
Once the InsightFacility is connected to the Cloud, the “Cloud connection status”
indicator will change from red to green, and the “Number of transmitted messages”
will start to increase. You can also check the “Last data transfer time from cloud” to
check the last time your InsightFacility sent a message to the Cloud. This information
can be helpful to troubleshoot connectivity issues.
InsightFacility Owner's Guide Configuring Devices
57 990-91411A