Schneider Conext SW AC Stacking Kit

975-0682-01-01 REV C Printed in China
Copyright © 2013 Schneider Electric. All Rights Reserved. All trademarks are owned by Schneider Electric Industries SAS or its affiliated companies.
For use by qualified personnel only.
Page 2 of 2
Conext SW AC Stacking Kit 120/240V (865-1019)
Exclusion for Documentation
UNLESS SPECIFICALLY AGREED TO IN WRITING, SELLER
(A) MAKES NO WARRANTY AS TO THE ACCURACY, SUFFICIENCY OR SUITABILITY OF ANY TECHNICAL OR OTHER INFORMATION PROVIDED IN ITS MANUALS OR OTHER DOCUMENTATION;
(
B) ASSUMES NO RESPONSIBILITY OR LIABILITY FOR LOSSES, DAMAGES, COSTS OR EXPENSES, WHETHER SPECIAL, DIRECT, INDIRECT, CONSEQUENTIAL OR INCIDENTAL, WHICH MIGHT
ARISE OUT OF THE USE OF SUCH INFORMATION. THE USE OF ANY SUCH INFORMATION WILL BE ENTIRELY AT THE USER’S RISK; AND
(C) REMINDS YOU THAT IF THIS MANUAL IS IN ANY LANGUAGE OTHER THAN ENGLISH, ALTHOUGH STEPS HAVE BEEN TAKEN TO MAINTAIN THE ACCURACY OF THE TRANSLATION, THE
ACCURACY CANNOT BE GUARANTEED. APPROVED CONTENT IS CONTAINED WITH THE ENGLISH LANGUAGE VERSION WHICH IS POSTED AT WWW.SCHNEIDER-ELECTRIC.COM.
Installation Guide
60A
30A30A
60A
30A30A
60A
30A30A
60A
30A30A
60A
30A30A
60A
30A30A
60A
30A30A





INSTALL
JUMPER BARS
60A
30A30A
60A
30A30A
PUT ALL
SCREWS
BACK
TIGHTEN THE SCREWS
INSTALL THE
INTERLOCK PLATE
EQUIPMENT DAMAGE
Failure to follow these instructions can
cause equipment damage.
Once installed do not remove the breaker
interlock plate.
The interlock plate can be moved but not
removed. See intructions on the right.
NOTICE
INVERTER 1 AC INPUT L1
INVERTER 1 AC INPUT L2
INVERTER 2 AC INPUT L1
INVERTER 2 AC INPUT L2
INVERTER LOAD PANEL
INVERTER 1 AC OUTPUT L1
INVERTER 1 AC OUTPUT L2
INVERTER 2 AC OUTPUT L1
INVERTER 2 AC OUTPUT L2
AC SOURCE L2
AC SOURCE L1
AC OUT BYPASS AC IN
AC OUT BYPASS AC IN
BYPASS INVERTER
NOTE: The L1 BUS and
L2 BUS are positioned
here differently and are
intended for illustration
purposes only.
Actual positions are
labeled within the unit.
RESERVE THESE TWO SPOTS
FOR 60 A BREAKERS
• Turn all breakers to OFF position.
• Loosen the interlock’s screws.
• Slide it to position.
• Re-tighten its screws to secure the interlock plate in place.
To move the interlock plate:
INVERTER 1
AC OUTPUT N
INVERTER 2
AC OUTPUT N
INVERTER 1
INVERTER 2