Instruction Manual
Table Of Contents
- About This Guide
- Contents
- Introduction
- Installation
- Configuration
- Operation
- Troubleshooting
- Specifications
- Conext System Control Panel Menus
- Boost Charging
- Index
Operation
4–12 975-0400-01-01 Revision H
This manual is for use by qualified personnel only.
Auxiliary Output Overload Fault. This fault appears when
too much current is being drawn from the auxiliary output.
The fault triggers when the auxiliary output voltage falls
more than 1 V below the auxiliary output voltage for three
seconds.
Ground Fault appears when a ground fault causes the
ground fault protection (GFP) fuse to blow. The Ground
Fault message clears after system power is removed, the
ground fault is corrected, the GFP fuse is replaced, and
system power is restored. See Chapter 5,
“Troubleshooting”.
Table 4 - 6 Fault and Warning Messages
Display Description