Instruction Manual

Conext System Control Panel Menus
B–4 975-0400-01-01 Revision H
This manual is for use by qualified personnel only.
Table B - 2 Screen and menu descriptions
Screen or menu Description
Startup screen Appears for a few seconds after the system starts up or when the system
has been reset.
System Home screen Displays status information for the power system, consisting of all Xanbus-
connected devices on a single network. The System Home screen
appearance varies with the status of the inverter/charger and other
Xanbus-enabled devices in the power system. The System Home screen
always features a “Menu” arrow pointing to the Enter button. Pressing Enter
takes you to the Select Device menu.
XW MPPT Home screen Displays status information for the solar charge controller.
Select Device menu Displays a list of Xanbus-enabled devices in the system, including the solar
charge controller and the SCP. The length of this menu depends on how
many Xanbus-enabled devices are installed in the system. This menu also
contains the clock menu (where you can set the time and date) and the
system settings menu (where you can change system modes). The System
Panel, Clock, and System Settings menus are always available from the
Select Device menu, regardless of the number of Xanbus-enabled devices
installed.
XW MPPT Setup menu Displays status information and changeable settings. Changeable settings
are identified by the square brackets [ ] around values in the right-hand
column.