Instruction Manual

Using the SCP
975-0400-01-01 Revision H B–5
This manual is for use by qualified personnel only.
Changing Settings Using the SCP
If you need to change a solar charge controller setting, use the buttons on the
SCP to perform three basic steps:
1. View the Select Device menu.
2. Select the solar charge controller from the Select Device menu.
3. Select and adjust a changeable setting on the solar charge controller Setup
menu. See page B–8.
Each of these three steps is described in detail in the following sections.
Viewing the Select Device Menu
The Select Device menu is where you select a Xanbus-enabled device to monitor
or configure. The number of items on the Select Device menu depends on how
many devices are installed in your Xanbus system.
To view the Select Device menu:
◆ On the System Home screen, press Enter.
Viewing the solar charge controller Setup Menu
On the Select Device menu, select the solar charge controller to view and
change its settings.
Note: You can also view the solar charge controller Setup menu by pressing
Enter from the solar charge controller Home screen. See “Charge Controller
Home Screen” on page B–10.
Important: You can always identify the System Home screen by the menu arrow
in the bottom left corner of the screen. The menu arrow indicates the Enter button
on the System Control Panel, which you press to view the Select Device menu.
Figure B-3 Selecting the solar charge controller
Select Device
MPPT60 01