Instruction Manual

Conext System Control Panel Menus
B–6 975-0400-01-01 Revision H
This manual is for use by qualified personnel only.
To select the solar charge controller from the Select Device menu:
1. On the Select Device menu, use the down arrow button to highlight
MPPT60 150.
2. Press Enter. The Setup menu appears.
Charge Controller Setup Menu
The Setup menu allows access to the Meters screen and several other
commands that control solar charge controller operation.
Figure B-4 Charge Controller Setup Menu
Table B - 3 Charge Controller Setup Menu
Menu Item Description
Meters Displays the Meters screen.
Force Chg Causes the current charge stage to change to the selected
stage.
Equalize Starts or stops battery equalization.
Mode Selects the solar charge controller operating mode: Operating
or Standby.
Clear Faults/
Warnings
Clears any active faults or warnings. If the fault or warning
condition is still present, the fault or warning message may
reappear.
View Device
Info
Displays the Device Info screen. On the Device Info screen you
can view the Warning Log, Fault Log and Event Log.
Basic
Settings
Displays the solar charge controller Basic or Advanced
configuration settings (to change to Advanced Settings, press
Enter + up arrow + down arrow).
MPPT60 01: Setup
Meters
[Bulk]
[Disabled]
[Operating]