Instruction Manual
Table Of Contents
- About This Guide
- Contents
- Introduction
- Installation
- Configuration
- Operation
- Troubleshooting
- Specifications
- Conext System Control Panel Menus
- Boost Charging
- Index
Installation
2–6 975-0400-01-01 Revision H
This manual is for use by qualified personnel only.
Removing Knockouts
Six dual and two single knockouts are provided for routing battery, PV array, BTS,
and network cables into the solar charge controller. Use bushings or conduits to
protect the wiring from damage from rough edges around the knockout holes.
When removing knockouts, ensure that no metal shavings or fragments fall into
the wiring compartment.
Figure 2-2 Removing the Wiring Compartment Cover
Remove screws to access
the wiring terminals.
Important: Do not drill, cut, or punch holes in the solar charge controller. Use
only the knockouts provided for conduit entry.