Instruction Manual

Installation
2–8 975-0400-01-01 Revision H
This manual is for use by qualified personnel only.
Mounting the Charge Controller
The solar charge controller is vertically mounted using three #10 × ½-inch or #12
× ½-inch (12.5 mm) pan-head screws.
To mount the solar charge controller:
1. Remove the wiring compartment cover.
2. Mark the location of the keyhole slot on the wall.
3. Secure the top mounting screw in the location marked. Leave the screw head
backed out approximately ¼ inch (6 mm).
4. Place the controller onto the screw and pull it down into the keyhole slot.
5. Insert two screws in the two mounting holes provided to secure the unit to the
wall.
6. Provide strain-relief clamps or conduit to prevent damage to the circuit board
and terminal block from pulling on the wires.
Figure 2-5 Mounting the Conext MPPT Solar Charge Controller
Secure with two
more screws.
Place keyhole slot
over the mounting
screw.
¼"
(6 mm)