Instruction Manual

Configuration Screens
975-0400-01-01 Revision H 2–37
This manual is for use by qualified personnel only.
4. Press Enter.
The settings are automatically copied from the selected unit.
5. Uncover the PV array and/or apply power with the disconnect or selector
switch.
The solar charge controller starts up in sleep mode and waits for a short period to
determine that the input voltage is greater than the output voltage. After the input
voltage exceeds the output voltage by the required margin for 10 seconds, the
unit begins operating.
Note
: The Copy From command will not give you any indication that it has
completed its task. However, you can quickly check for yourself that the
charger settings you have chosen have been copied properly by viewing some
of the settings you originally configured.