Instruction Manual

Configuration
3–2 975-0400-01-01 Revision H
This manual is for use by qualified personnel only.
Configuring the Charge Controller
The following sections describe how to configure the Conext MPPT Solar Charge
Controller (charge controller) for the desired application and function.
The solar charge controller is configured using the four buttons on the front of the
unit.
NOTICE
EQUIPMENT DAMAGE
Any configuration (change in settings) made when the MPPT is in Operating
mode will not be saved unless the MPPT is put in Standby and then back to
Operating mode. It is recommended to put the MPPT in Standby mode prior to
changing basic or advanced settings. Then return to Operating mode for the
settings to take effect.
Failure to follow these instructions can damage equipment.
Table 3 - 1 Charge controller buttons
Button Function
Enter • Displays the next screen level. For example, pressing Enter
from the Battery Menu selection screen displays the first
configurable item on the Battery menu.
• Selects and confirms selection of a menu item
Up arrow • Displays previous menu or menu item. For example, pressing
the Up arrow from the Battery Menu selection screen displays
the History Menu selection screen.
• Increases a selected value
Down
arrow
• Displays the next menu or menu item. For example, pressing
the Down arrow from the Battery Menu selection screen
displays the Input Menu selection screen.
• Decreases a selected value
Exit • Cancels selection of a menu item
• Displays the previous screen level. For example, pressing Exit
from the Equalization Reminder screen on the Battery Menu
displays the Battery Menu selection screen. Pressing Exit
again displays the top-level operating screens.