Instruction Manual

Configuration Menus
975-0400-01-01 Revision H 3–3
This manual is for use by qualified personnel only.
Configuration Menus
The menus for setup and monitoring solar charge controller performance are
shown in Figure 3-1 and Figure 3-2.
Basic and Advanced Menus
The menus can be viewed in basic and advanced formats. Basic menus contain
items you may have to view and adjust on a routine basis. Advanced menus
contain items intended for service personnel and one-time setup, such as
auxiliary output configuration and defining custom battery types.
The solar charge controller is shipped from the factory with only basic menu
items enabled. You can choose to view the basic or advanced menus on the
Display Menu (see “Configuring the LCD” on page 3–17).
The Input Menu, Auxiliary Menu, Device Menu, and Reset Menu are advanced
menus only, as are some items on the History Menu and Battery Menu.
Figure 3-1 Configuration Menu Selection Screens








= Advanced menu

Not a configuration menu. See page 4–9.
View and reset data logs and monitor solar charge
controller performance. See page 4–13.
Configure battery and battery charger parameters. See
page 3–5 and page 4–14.
Turn off automatic MPPT and set a reference voltage.
See page 3–12.
Set up the auxiliary output. See page 3–13.
Set up custom screens and LCD appearance, and select to view
basic or advanced menus. See page 3–17.
Reset the Charge Controller to factory defaults. See page 3–21.
Change the mode of operation and view the network ID of the
Charge Controller. See page 3–19.