Instruction Manual

Configuration
3–8 975-0400-01-01 Revision H
This manual is for use by qualified personnel only.
A safety notice when selecting battery charge settings when the Conext-
MPPT60-150 is part of a power system with a Conext XW+ inverter/charger is
shown below.
Setting a Custom Battery Type
NOTICE
DAMAGE FROM HAVING DIFFERENT CHARGER SETTINGS
Make sure that all Conext-MPPT60-150 units and all Conext XW+ inverter/
charger units in a power system setup has the same Charger Settings. For
example, if one Conext-MPPT60-150 unit has a Battery Type of Flooded, all
Conext-MPPT60-150 units including all Conext XW+ inverter/charger units
must have the same Battery Type. See NOTE below.
To copy the settings to one Conext-MPPT60-150 unit from another, see “To
copy the solar charge controller setup to another unit:” on page 2–36.
Failure to follow these instructions may damage the battery/batteries.
Note: If Cascading is Enabled in SCP, the charger settings will cascade to
other Conext-MPPT60-150 devices with the same DC Associations. However
they will not cascade to other device types such as Conext XW+, Conext SW, or
Conext Battery Monitor even if they have the same DC associations. Make sure
that the charger settings are configured correctly on the other device types.
WARNING
FIRE OR EXPLOSION HAZARD
Incorrect settings for speciality batteries, such as lithium ion, can cause
dangerous battery over-charging. Always connect the Battery Temperature
Sensor (BTS). Custom battery settings should be configured by qualified
personnel only.
Failure to follow these instructions can result in death or serious injury.
NOTICE
EQUIPMENT DAMAGE
To avoid damaging your batteries during charging or equalization, consult
your battery manufacturer and associated documentation before setting a
custom battery type.
Failure to follow these instruction can damage the equipment.