Instruction Manual

Viewing Operating Status
975-0400-01-01 Revision H 4–3
This manual is for use by qualified personnel only.
Normal Operation
All readings on the solar charge controller LCD are refreshed every two seconds.
A default top-level display is available at all times (see Table 4-1). The additional
screens can be displayed by pressing the down arrow or up arrow button. You
can also configure the solar charge controller to scroll through each operating
screen in sequence (changing every four seconds). See “Configuring the LCD”
on page 3–17.
Figure 4-1 Operating Screens






 





Screen will
appear if
configured
Screen will
appear if
configured
Enter
to view configuration
and history menus
Press






Screen will appear if unit is in float ,
or is not charging and the charge
algorithm is set for 3-stage
Screen will appear if unit is in float ,
or is not charging and the charge
algorithm is set for 3-stage
Table 4 - 1 Default Operation Screen
Display
a
a.All numbers in this table and following tables are examples only. Your unit’s details and
performance data will vary.
Description

 
Power being produced by the solar charge controller
now.
Measured output voltage and output current.