Installation Guide

DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, ARC FLASH, AND FIRE
Installation of this equipment should only be planned and performed by qualified personnel
in accordance with all applicable installation codes. See "Audience" on page2 for the
definition of qualified personnel.
Failure to follow these instructions will result in death or serious injury.
WARNING
HAZARD OF ELECTRIC SHOCK, BURNS, FIRE, AND EXPLOSION
Follow all instructions and electrical, physical, and environmental installation specifications
in this Guide.
Failure to follow these instructions can result in death, serious injury, or equipment
damage.
Required Materials and Tools
The following materials are shipped with the charge controller:
n One Conext MPPT 80 or MPPT 100 Solar Charge Controller
n One Conext MPPT 80 and MPPT 100 Solar Charge Controller Installation Guide
n One Conext MPPT 80 and MPPT 100 Solar Charge Controller Owner's Guide
n One Factory Test Certificate
n One Battery Temperature Sensor (BTS)
n One fuse: 1 A 600 VAC/DC
n One network terminator
The following tools are required for installation:
n Phillips head screwdriver
n Wire cutters and wire strippers
Required Accessories
A Conext System Control Panel (SCP) is required for installation of the charge controller.
However, in place of the SCP, a Conext Gateway can be used if you would like to
configure and monitor the charge controller through a web-interface on a PC or laptop.
For more information about accessories, see Specifications on page 56.
PV Array Requirements
NOTE: The following information only provides general guidelines. PV array installation
is subject to installation codes and, in some areas, inspection and approval by the
authority having jurisdiction. For example, installations in the United States must be
compliant with NEC and, in particular, Article 690.
Conext MPPT 80 and MPPT 100 Installation Guide Installation
23 This document is for use by qualified personnel 990-91319