Installation Guide

Figure 2Minimum Clearance Requirements
Removing the Wiring Compartment Cover
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, ARC FLASH, AND FIRE
Before removing the wiring compartment cover, make sure all electrical power sources
have been disconnected for at least two minutes. Before energizing the charge controller,
make sure the wiring compartment cover has been replaced and all fasteners are in place.
Failure to follow these instructions will result in death or serious injury.
Before mounting, remove the wiring compartment cover to access the mounting holes
and the wiring terminals. The wiring compartment cover is secured with two screws on
the front of the charge controller (see ).
Figure 3Removing the wiring compartment cover
Remove two screws to
access the wiring terminals.
The wiring compartment (see Figure 4) contains a flexible Lexan™ barrier used to
segregate low voltage battery and high voltage PV wire routing. In some instances, you
must manipulate this barrier to provide a passage for the battery or PV cables which run
Installation Conext MPPT 80 and MPPT 100 Installation Guide
990-91319 This document is for use by qualified personnel 26