Installation Guide

Figure 5Knockout dimensions
26.4 (1.03)
29.0 (1.14)
45.4 (1.78)
55.2 (2.17)
85.5 (3.37)
22.8 (0.90)
62.3 (2.45)
82.8
(3.26)
102.5 (4.03)
Ø 6.5 (0.25) 2PL
150.0 (5.9)
35.0 (1.38)
85.0 (3.35)
110.0 (4.33)
169.0 (6.65)
22.8 (0.90) 66.5 (3.52)
131.5 (5.18)
719.0 (28.3)
Ø 28.2 (1.11)/ Ø 22.2(0.87)
DUAL KNOCKOUT
Ø 35.0 (1.38) KNOCKOUT 2PL
Ø 44.0 (1.73) KNOCKOUT
Figure 6Dimensions and knockout locations
764.0
(30.0)
220.5 (8.68)
44.0 (1.73) KNOCKOUT
DUAL KNOCKOUT
28.2 (1.11)/ 22.2(0.87)
35.0 (1.38)/
28.2 (1.11)
DUAL
KNOCKOUT
3PL
108.4 (4.27)
61.9
(2.44) 673.4 (26.5)
219.7 (8.65)
Conext MPPT 80 600
!
Event
Equalize
Charging
Mounting the Charge Controller
The charge controller must be vertically mounted to the wall using three ¼-inch × ½-inch
(6.35 mm × 12.5 mm) pan head screws. Alternatively, the it can also be mounted on the
side of the PDP (the hardware is provided with the charge controller).
To mount the charge controller on the wall (see Figure 7):
Installation Conext MPPT 80 and MPPT 100 Installation Guide
990-91319 This document is for use by qualified personnel 28