Installation Guide

Accessories
Conext System Control Panel
The Conext System Control Panel (SCP) (Part Number 865-1050) is required for
installation of the charge controller and is strongly recommended for ongoing operation.
As the primary interface to the charge controller, the SCP is used for setup and
configuration. Once installation is complete, you can use the SCP for monitoring and
fault reporting. Only one SCP is required to monitor multiple charge controllers.
Note: You must use the SCP with firmware version 1.05.00 or higher for full compatibility
with the charge controller. For information on updating your firmware, contact customer
service. The Conext Config Tool or Conext Gateway is required for upgrading.
Conext Gateway
In place of the SCP, the Conext Gateway (Part Number 865-0329) can also be used. The
Conext Gateway allows you to configure and monitor the charge controller through a web
interface on a PC or laptop. See the Conext Gateway Owner's Guide (975-0806-01-xx).
Conext Config Tool
The Conext Config Tool (Part Number 865-1155) is a commissioning tool used for
configuring or upgrading a Conext system.
Conext MPPT 80 and MPPT 100 Installation Guide Specifications
63 This document is for use by qualified personnel 990-91319