Owner's Guide

Viewing Status Information on the Charge Controller
The charge controller has three LEDs for displaying basic operating information. They are
Charging (green), Event (red), and Equalize (orange).
Figure 7Charge controller status LEDs
Event
!
Equalize
Charging
LED Description
Charging
(Green)
Solid when the charge controller is connected to a battery, providing visual
feedback that the charge controller is powered on.
Flashing at a variable rate when the charge controller is charging a battery.
Slow flashing indicates a low charge rate, and fast flashing indicates a faster
charge rate.
Event
(Red)
Solid when the charge controller has detected an error or fault condition.
Flashing at a constant rate when the charge controller has detected a warning
condition.
View the error, fault, or warning and its description on the SCP.
Equalize
(Orange)
n Solid when an equalize charge has been enabled via the SCP but has not
yet started (the charge controller must complete a full bulk and absorption
cycle before it can begin the equalize cycle).
n Flashing at a constant rate when the charge controller is performing the
equalize charge to the batteries. After the equalize charge has completed,
the LED goes dark.
Table 11Charge controller status LEDs
Conext MPPT 80 and Conext MPPT 100 Owner’s Guide Operation
44 This document is for use by qualified personnel 990-6214B