Owner's Guide

System
Status
screen
Displays status information for the power system, consisting of all Xanbus- connected devices on a single network.
The System Status home screen appearance varies with the status of the Conext XW+ or Conext XW Pro
Inverter/Charger and other Xanbus-enabled devices in the power system. The System Status home screen
features a menu arrow pointing to the Enter button. Pressing Enter takes you to the Select Device menu.
XW
MPPT
Home
screen
Displays status information for the charge controller.
Select
Device
menu
Displays a list of Xanbus-enabled devices in the system, including the charge controller and the SCP. The length of
this menu depends on how many Xanbus- enabled devices are installed in the system. This menu also contains the
clock menu (where you can set the time and date) and the system settings menu (where you can change system
modes). The System Panel, Clock, and System Settings menu items are available from the Select Device menu,
regardless of the number of Xanbus-enabled devices installed.
XW
MPPT
Setup
menu
Displays status information and changeable settings. Changeable settings are identified by square brackets []
around values in the right-hand column.
Changing Settings Using the SCP
To change a charge controller’s setting, use the buttons on the SCP to perform three
basic steps:
n View the Select Device menu.
n Select the charge controller from the Select Device menu.
n Select and adjust a changeable setting on the charge controller’s Setup menu. See
Configuration Settings on page 78.
Each of these three steps is described in detail in the following sections.
Note:You can also view the charge controller’s Setup menu by pressing Enter from the
charge controller’s home screen. See “Home Screen” in Monitoring the Unit on page 81.
Viewing the Select Device Menu
The Select Device menu is where you select a Xanbus-enabled device to monitor or
configure. The number of items on the Select Device menu depends on how many
devices are installed in your system.
To view the Select Device menu:
n On the System Status screen, press Enter.
Note: You can identify the System Status home screen by the menu arrow in the bottom
left corner of the screen. The menu arrow indicates the Enter button on the SCP, which
you press to view the Select Device menu.
Viewing the Setup Menu
On the Select Device menu, select the charge controller to view and change its settings.
Conext MPPT 80 and Conext MPPT 100 Owner’s Guide Conext System Control Panel Menus
76 This document is for use by qualified personnel 990-6214