Owner's Guide

Figure 16Selecting the unit
To select the charge controller from the Select Device menu:
n Press the down arrow button to highlight XW MPPT80 xx, where xx is the device
number.
n Press Enter.
The Setup menu appears.
The Setup Menu
The Setup menu allows access to the Meters screen and several other commands that
control the charge controller’s operation.
Figure 17Setup menu
Menu Item Description
Meters Displays the Meters screen.
Harvest Logs
Displays the charge controller’s daily, monthly, and yearly performance logs. See “Viewing Harvest Logs” in
Viewing Fault, Error, and Warning Logs on page 53.
Force Chg Causes the current charge stage to change to the selected stage.
Equalize Starts or stops battery equalization.
Mode Sets the charge controller’s operating mode.
Clear Faults
Warnings
Clears any active faults or warnings. If the fault or warning condition is still present, the fault or warning
message could reappear.
View Device
Info
Displays the Dev Info screen. On the Dev Info screen you can view the warning, fault, and event logs.
Table 23 Setup menu
Conext System Control Panel Menus Conext MPPT 80 and Conext MPPT 100 Owner’s Guide
990-6214 This document is for use by qualified personnel 77