Owner's Guide

Basic
Settings
Displays the charge controller’s basic or advanced configuration settings. To change to advanced settings,
press the Enter, up arrow, and down arrow buttons simultaneously.
Configuration Settings
The configuration settings can be viewed in basic and advanced formats.
Basic menu
The basic menu contains items you might have to view and adjust on a routine basis.
Advanced menu
Note:The images below are for illustrative purposes only. The information displayed on
the menu screens will vary depending on the charge controller model (Conext MPPT 80
600 or Conext MPPT 100 600).
The advanced menu contains items intended for service personnel and one-time setup,
such as auxiliary output and custom battery configuration. To display the Advanced
Settings menu item instead of the Basic Settings menu item, perform the following
special keypress:
n From the Setup menu, press the Enter, up arrow, and down arrow buttons
simultaneously.
On the Setup menu, Basic Settings disappears from the bottom of the list, and
Advanced Settings appears at the top of the list.
After configuring the charge controller, help prevent unintended advanced configuration
by using the combined keypress again to hide the advanced menu items.
Note:
n This keypress displays advanced settings for every device in the system.
n After performing the keypress, Advanced Settings appears at the top of the Setup menu.
When the keypress is performed again, the Setup menu displays Basic Settings as the
last item on the menu.
The charge controller Config menu contains sub-menus for configuring:
n Multiple-unit operation
n Charger and battery settings
n Input settings
n Auxiliary output settings.
To view the Config menu:
n From the Setup menu, with Basic Settings or Advanced Settings
highlighted, press Enter.
Conext MPPT 80 and Conext MPPT 100 Owner’s Guide Conext System Control Panel Menus
78 This document is for use by qualified personnel 990-6214