Schneider Electric Conext Combox Owners Guide

Safety
975-0679-01-01 Revision E ix
NOTICE
EQUIPMENT DAMAGE
• All cables connected to the Conext ComBox must run indoors and not be
susceptible to lightning strikes.
• Turn OFF all devices before connecting cables. The Conext ComBox does
not have an ON/OFF switch.
• Do not connect an Ethernet cable from the Conext ComBox to the WAN/
MODEM port on the network router.
• Do not connect an Ethernet cable plug into a Xanbus port on the Conext
ComBox.
• Do not connect a Xanbus RJ-45 cable plug into the 10/100 Ethernet port of
the Conext ComBox.
• Do not connect any port on the Conext ComBox to an outside line or to a
public telecommunication network.
• Ensure that the device connected on the Xanbus network is in standby
mode before changing settings. Do not change any settings unless you are
familiar with the device.
• Changes to any TCP/IP-related settings should only be performed by a
qualified IT professional.
Failure to follow these instructions can damage equipment or affect
network performance.
NOTICE
EQUIPMENT DAMAGE
• Do not disassemble the Conext ComBox.
• See Warranty for instructions on obtaining service.
• The Conext ComBox contains no user serviceable parts. Attempting to
service the Conext ComBox yourself will void your warranty.
Failure to follow these instructions can damage equipment.
Note: This device can be configured to connect to the Internet using port-
forwarding in your network router’s settings. There is a security risk in port-
forwarding unencrypted network traffic over a public network (Internet). Use of
a VPN or a secure tunnel to route Conext ComBox communication via the
Internet is recommended.