Schneider Electric AGS User Manual

Indicator Lights and Connectors
975-0307-01-01 Rev G 1–7
Bottom Panel
Connectors Two network ports on the bottom panel connect the Conext AGS to the
Xanbus network. A 20-contact pluggable connector (also on the bottom
panel) allows the Conext AGS to connect to the generator’s starting
circuitry, thermostats and external switches.
Tab le 1- 1 Front panel features
LED Description
Power
Power light (green) indicates the Conext AGS
is
receiving network power.
Generator On Generator On light (green) indicates the generator is
running. This light turns on when the generator run
signal is active. See “Important” on page 2–29.
Network
Network light (green) indicates the Conext AGS
is
communicating with other Xanbus-enabled devices.
Fault Fault light (red) indicates an Conext AGS fault has
occurred.
See “Troubleshooting” on page 5–1 for information
about Conext AGS faults.
Figure 1-3 Conext AGS Bottom Panel
CA U T I O N:
Co n n e c t o n l y t o C l a s s
2ELVcircuits.
Refer tomanual.
!
Netw o rk
Ge n e r a t o r
Xanbus Network Ports
20-contact Generator
Connector Port
975-0307-01-01_RevG(AGS-Owners).book Page 7 Thursday, August 27, 2015 2:01 PM