Schneider Electric AGS User Manual

Introduction
1–8 975-0307-01-01 Rev G
Network Port
Each network port can accept an eight-pin RJ-45 plug attached to a
Category 5 (CAT 5) Xanbus network cable. Depending on the
installation, both ports may be required.
20-contact
Connector
The 20-contact connector supports a wiring harness (included) that
connects the Conext AGS to a generator and thermostats. The wiring
harness also provides lines for connecting external generator shutdown
sensors or switches and external generator ON/OFF controls.
NOTICE
EQUIPMENT DAMAGE
Connect the Conext AGS only to other Xanbus compatible devices.
Although the cabling and connectors used in this network system are
the same as those used for Ethernet, this network is not an Ethernet
system.
Failure to follow these instructions may result in equipment
damage.
Figure 1-4 Wiring Harness
975-0307-01-01_RevG(AGS-Owners).book Page 8 Thursday, August 27, 2015 2:01 PM