Schneider Electric AGS User Manual

Installing the AGS
975-0307-01-01 Rev G 2–5
Mounting the Unit
The Conext AGS is to be mounted vertically on a wall with the connectors
facing downwards.
To mount the Conext AGS:
1. Hold the unit flush and square against the wall, panel, or horizontal
surface.
• If the mounting surface requires pre-drill holes for the screws,
use the supplied mounting template to mark, then drill, four
holes.
2. With a Phillips screwdriver and the supplied #6 screws, secure each
corner of the Conext AGS to the mounting surface.
Wiring to the 20-Contact Connector
Important: Because each installation varies according to the
location, the type of generator, and the overall complexity of the
Xanbus network, these instructions offer only general guidelines for
the many installation options available.
WARNING
SHOCK HAZARD
Before installing the Conext AGS as part of a pre-existing Xanbus
system, put the system in Standby in order to disable the electrical
operation of networked devices. See “Placing the Conext AGS in
Standby Mode” on page 4–6.
Failure to follow these instructions can result in death or serious
injury.
WARNING
SHOCK HAZARD
All installation wiring should be performed by a qualified installer or
electrician.
Failure to follow these instructions can result in death or serious
injury.
975-0307-01-01_RevG(AGS-Owners).book Page 5 Thursday, August 27, 2015 2:01 PM