Conext SW 4024-120 Install Guide
Table Of Contents
- Conext™ SW Inverter/Charger
- Exclusion for Documentation
- Document Number: 975-0639-01-03 Revision: Date: 5-2020
- Contact Information solar.schneider-electric.com
- Information About Your System
- About This Guide
- Important Safety Instructions
- Safety Information
- Precautions When Working With Batteries
- FCC Information to the User
- Installation
- Materials List
- Conext SW Front and Side Panels
- Conext SW Supplied Accessories
- Conext SW Required Accessory
- Installation Information
- Before You Begin the Installation
- Installation Codes
- Xanbus Network System
- Xanbus System
- Xanbus-enabled Products and Other Accessories
- Installation Planning
- Planning Preparations
- Components of the Inverter Power System
- Unpacking and Inspecting the Conext SW Inverter/Charger
- Installation Tools and Materials
- Inverter/Charger Installation
- Overview
- Step 1: Choosing a Location for the Inverter/Charger
- Step 2: Mounting the Inverter/Charger
- Step 3: Connecting the AC Input and AC Output Wires
- AC System Bonding
- Step 4: Installing the DC Switchgear and Connecting the DC Cables
- Step 5: Connecting the BTS and Xanbus-enabled Components
- Step 6: Performing Checks Prior to Initial Start-Up
- Step 7: Testing Your Installation
- Battery Information
- Battery Bank Sizing
- Estimating Battery Requirements
- Restrictions on Motor Size
- Battery Cabling and Hook-up Configurations
- Specifications
- Inverter Specifications
- Charger Specifications
- AC Transfer Specifications
- Physical Specifications
- Environmental Specifications
- Regulatory
- Wiring Diagrams
- Single-Inverter System (Off-Grid/Power Backup)
- Single-Inverter System Renewable Energy (Solar)
Installation
1–8 975-0639-01-03
This guide for use by qualified personnel only
Installation Information
Before You Begin the Installation
Before beginning your installation:
• Read the entire Installation Guide so you can plan the installation from
beginning to end.
• Assemble all the tools and materials you require for the installation.
• Review the Important Safety Instructions on page v.
• Be aware of all safety and electrical codes which must be met.
Installation Codes
Applicable installation codes vary depending on the specific location and
application of the installation. Some examples are:
Applicable installation codes vary depending on the specific location and
application of the installation. Some examples are:
• National Electrical Code (NFPA 70)
• Canadian Electrical Code (CSA C22.1)
DANGER
ELECTRICAL SHOCK AND FIRE HAZARD
• All wiring must be done by qualified personnel to ensure compliance with
all applicable installation codes and regulations.
• Disconnect and lockout all AC and DC power sources.
• Disable and secure all AC and DC disconnect devices and automatic
generator starting devices.
Failure to follow these instructions will result in death or serious injury.