Conext SW 4024-120 Install Guide
Table Of Contents
- Conext™ SW Inverter/Charger
- Exclusion for Documentation
- Document Number: 975-0639-01-03 Revision: Date: 5-2020
- Contact Information solar.schneider-electric.com
- Information About Your System
- About This Guide
- Important Safety Instructions
- Safety Information
- Precautions When Working With Batteries
- FCC Information to the User
- Installation
- Materials List
- Conext SW Front and Side Panels
- Conext SW Supplied Accessories
- Conext SW Required Accessory
- Installation Information
- Before You Begin the Installation
- Installation Codes
- Xanbus Network System
- Xanbus System
- Xanbus-enabled Products and Other Accessories
- Installation Planning
- Planning Preparations
- Components of the Inverter Power System
- Unpacking and Inspecting the Conext SW Inverter/Charger
- Installation Tools and Materials
- Inverter/Charger Installation
- Overview
- Step 1: Choosing a Location for the Inverter/Charger
- Step 2: Mounting the Inverter/Charger
- Step 3: Connecting the AC Input and AC Output Wires
- AC System Bonding
- Step 4: Installing the DC Switchgear and Connecting the DC Cables
- Step 5: Connecting the BTS and Xanbus-enabled Components
- Step 6: Performing Checks Prior to Initial Start-Up
- Step 7: Testing Your Installation
- Battery Information
- Battery Bank Sizing
- Estimating Battery Requirements
- Restrictions on Motor Size
- Battery Cabling and Hook-up Configurations
- Specifications
- Inverter Specifications
- Charger Specifications
- AC Transfer Specifications
- Physical Specifications
- Environmental Specifications
- Regulatory
- Wiring Diagrams
- Single-Inverter System (Off-Grid/Power Backup)
- Single-Inverter System Renewable Energy (Solar)
Installation
1–16 975-0639-01-03
This guide for use by qualified personnel only
Unpacking and Inspecting the Conext SW Inverter/Charger
To unpack and inspect:
1. Unpack the unit and check the materials list. If anything is missing from the
shipping box, contact your local Schneider Electric customer service
representative. See page ii for information.
2. Record the serial number of the Conext SW and other purchase information
in the beginning section under Information About Your System of the Conext
SW Inverter/Charger Owner’s Guide.
3. Save your purchase receipt to use as proof of purchase. This receipt is
required if the inverter/charger requires warranty service.
4. Save the original shipping carton and packing materials. If the inverter/
charger needs to be returned for service, it should be shipped in the original
carton. Packing the Conext SW in the original shipping carton is also a good
way to protect the inverter/charger if it ever needs to be moved.
CAUTION
HEAVY LOAD HAZARD
Do not lift the unit by yourself. Use two people to lift and mount the unit. Always
use proper lifting techniques during installation to prevent injury.
Failure the follow these instructions can result in injury.
IMPORTANT: Keep the carton and packing material in case you need to return
the Conext SW for servicing.