Conext SW 4024-120 Install Guide
Table Of Contents
- Conext™ SW Inverter/Charger
- Exclusion for Documentation
- Document Number: 975-0639-01-03 Revision: Date: 5-2020
- Contact Information solar.schneider-electric.com
- Information About Your System
- About This Guide
- Important Safety Instructions
- Safety Information
- Precautions When Working With Batteries
- FCC Information to the User
- Installation
- Materials List
- Conext SW Front and Side Panels
- Conext SW Supplied Accessories
- Conext SW Required Accessory
- Installation Information
- Before You Begin the Installation
- Installation Codes
- Xanbus Network System
- Xanbus System
- Xanbus-enabled Products and Other Accessories
- Installation Planning
- Planning Preparations
- Components of the Inverter Power System
- Unpacking and Inspecting the Conext SW Inverter/Charger
- Installation Tools and Materials
- Inverter/Charger Installation
- Overview
- Step 1: Choosing a Location for the Inverter/Charger
- Step 2: Mounting the Inverter/Charger
- Step 3: Connecting the AC Input and AC Output Wires
- AC System Bonding
- Step 4: Installing the DC Switchgear and Connecting the DC Cables
- Step 5: Connecting the BTS and Xanbus-enabled Components
- Step 6: Performing Checks Prior to Initial Start-Up
- Step 7: Testing Your Installation
- Battery Information
- Battery Bank Sizing
- Estimating Battery Requirements
- Restrictions on Motor Size
- Battery Cabling and Hook-up Configurations
- Specifications
- Inverter Specifications
- Charger Specifications
- AC Transfer Specifications
- Physical Specifications
- Environmental Specifications
- Regulatory
- Wiring Diagrams
- Single-Inverter System (Off-Grid/Power Backup)
- Single-Inverter System Renewable Energy (Solar)
About This Guide
iv 975-0639-01-03
This guide for use by qualified personnel only
Abbreviations, Acronyms, and Symbols
Related Information
You can find more information about Schneider Electric as well as its products
and services at solar.schneider-electric.com.
AC Alternating Current LED Light Emitting Diode
AGS Automatic Generator Start SCP System Control Panel
BOS Balance of System SW Sine Wave
DC Direct Current VAC Volts, Alternating Current
PPE Personal Protective
Equipment
VDC Volts, Direct Current
PV Photovoltaic IP20 Ingress protection rating
Reference to see guide
(or manual) for more
information
Ground
AC DC
Denotes a steady LED Denotes a flashing LED
Inv Enabled – see
Owner’s Guide for
definition.
Gen Support – see
Owner’s Guide for
definition.
AC IN – see Owner’s
Guide for definition.
Charging – see Owner’s
Guide for definition.
Fault – see Owner’s Guide
for definition.
Warning – see Owner’s
Guide for definition.
Clear Fault | Reset – see
Owner’s Guide for
definition.
Inv Enable – see Owner’s
Guide for definition.