Conext SW 4024-120 Install Guide
Table Of Contents
- Conextâ„¢ SW Inverter/Charger
- Exclusion for Documentation
- Document Number: 975-0639-01-03 Revision: Date: 5-2020
- Contact Information solar.schneider-electric.com
- Information About Your System
- About This Guide
- Important Safety Instructions
- Safety Information
- Precautions When Working With Batteries
- FCC Information to the User
- Installation
- Materials List
- Conext SW Front and Side Panels
- Conext SW Supplied Accessories
- Conext SW Required Accessory
- Installation Information
- Before You Begin the Installation
- Installation Codes
- Xanbus Network System
- Xanbus System
- Xanbus-enabled Products and Other Accessories
- Installation Planning
- Planning Preparations
- Components of the Inverter Power System
- Unpacking and Inspecting the Conext SW Inverter/Charger
- Installation Tools and Materials
- Inverter/Charger Installation
- Overview
- Step 1: Choosing a Location for the Inverter/Charger
- Step 2: Mounting the Inverter/Charger
- Step 3: Connecting the AC Input and AC Output Wires
- AC System Bonding
- Step 4: Installing the DC Switchgear and Connecting the DC Cables
- Step 5: Connecting the BTS and Xanbus-enabled Components
- Step 6: Performing Checks Prior to Initial Start-Up
- Step 7: Testing Your Installation
- Battery Information
- Battery Bank Sizing
- Estimating Battery Requirements
- Restrictions on Motor Size
- Battery Cabling and Hook-up Configurations
- Specifications
- Inverter Specifications
- Charger Specifications
- AC Transfer Specifications
- Physical Specifications
- Environmental Specifications
- Regulatory
- Wiring Diagrams
- Single-Inverter System (Off-Grid/Power Backup)
- Single-Inverter System Renewable Energy (Solar)
Single-Inverter System (Off-Grid/Power Backup)
975-0639-01-03 3–3
This guide for use by qualified personnel only
Single-Inverter System (Off-Grid/Power Backup)
Figure 3-1 Single-Inverter System (Off-Grid/Backup) Overview
Communication
Loads
Vented Battery
Enclosure
Battery Bank
Inverter AC
Distribution
Panel
Utility Grid
AC Source(s)
AC Generator
DC Charging
and DC In
AC Out
AC In
Conext SW AC Switchgear
Conext SW DC Switchgear
Conext SW DC Switchgear
Automatic Generator
Start (optional)
System Control Panel
(optional)
Accessories
System Contro l Panel
Enter Exit
Fault/ Warning
System Status
Battery 20. 4 A 53. 9V
BatLev E -- F
Load 1235W
AC 1 115 W 3202V
Menu
Standby
12: 00 AM Ja n 01
Power
Generator On
Netwo rk
Fault
Automatic Generator Start
Conext ComBox
(optional)
Remote Switch
(optional)
Battery Temperature
Sensor
(optional)
DANGER
ELECTRICAL SHOCK AND FIRE HAZARD
Installation must be done by qualified personnel to ensure compliance with all
applicable installation codes and regulations. Instructions for installing the
Conext SW are provided in this installation guide for use by qualified installers
only.
Failure to follow these instructions will result in death or serious injury.