Conext SW 4048-120 Manual Addendum

Documentation Update
12 976-0315-01-01 Rev E
New Advanced Features Setting
LoadShave
Start
Sets the time for when load
shaving is engaged.
12:00 AM
Setting the Load
Shave Start and Load
Shave Stop to the
same time disables
scheduling.
LoadShave
Stop
Sets the time for when load
shaving is disengaged.
12:00 AM
AC Supp on
Soc
Enables or disables the SOC
monitoring for AC Support
Mode.
This setting must be enabled for
AC Supp Start Soc and AC
Supp Stop Soc to take effect.
Enabled Disabled,
Enabled
AC Supp Start
Soc
Sets the high percentage value
of the SOC of the battery for AC
Support Mode to engage.
Applicable only when AC Supp
on Soc is enabled.
80% 70% to 100%
AC Supp Stop
Soc
Sets the low percentage value
of the SOC of the battery for AC
Support Mode to disengage.
Applicable only when AC Supp
on Soc is enabled.
50% 20% to 60%
a.Applies to all CSW models.
Figure 9 Adv Features Menu Screen
Table 2 Adv Features Description and Values
Item Description Default Range
StoreInv
State
See “Storing the State of the
Inverter Mode” on page 8.
Enabled Enabled,
Disabled
AcCouple
For information on this feature
refer to the
AC Coupling
Solutions Guide
.
Disabled Enabled,
Disabled
Enhanced ACSup
See “Enhanced AC Support” on
page 4.
Disabled Disabled,
Enabled
Table 1 AC Support Menu Description and Values
a
Setting Description Default Range
CSW4024E 00: Adv Fea
EuroFreq
StoreInvState
AcCouple
EnhancedAcSup
PLSDelay
NoLoadVD
[Enabled]
[Enabled]
[Disabled]
[Disabled]
[Disabled]
[Disabled]
[*Enabled] [Disabled]
[Enabled] [*Disabled]
[Enabled] [*Disabled]
[Enabled] [*Disabled]
CSW4024E 00: Adv
Inverter Settings
Charger Settings
AC Settings
AC Support
Multi Unit Config
Restore Defaults
Adv Features
For details on EuroFreq, consult the Conext SW Owner’s Guide.