Schneider Electric User Guide

Troubleshooting
4–16 975-0240-01-01
Fault Messages
When the Conext XW+ detects a fault condition, the fault is displayed on the
Conext System Control Panel. The Conext XW+ also illuminates the Fault light on
the Conext System Control Panel and inverter information panel. A fault affects
the operation of the unit. See “Fault Types” on page 4–17 for an explanation of
the different fault types.
You can view the 20 most recent fault messages on the Conext System Control
Panel by selecting Fault Log from the Device Info menu in the Conext XW+ Setup
Menu.
If several faults occur before you can acknowledge or clear them, they are
displayed together on a fault list. This list contains messages from every Xanbus-
enabled device, not just the Conext XW+. You can select a message and view its
details from the fault list.
To view a message from a fault list:
1. On the list, use the up arrow or down arrow button to highlight the message
you want to view.
2. Press Enter. The complete message appears.
After viewing the message, you can return to the fault list by pressing Exit or
continue to the menu for the device that caused the fault by pressing Enter.
Each time you return to the list after viewing a complete message, the viewed
message is removed from the list.
If you have left the fault list, you can view faults at any time from the System
Settings menu.
To view a fault list:
1. On the Select Device menu, highlight System Settings and press Enter.
2. On the System Settings menu, highlight View Fault List and press Enter.
Conext XW+ Owner's Guide NA (975-0240-01-01).book Page 16 Monday, November 27, 2017 10:00 AM