Schneider Electric User Guide

Monitoring Operation with the Conext SCP
975-0240-01-01 2–15
Press the down arrow button from the Conext XW+ Home screen to display the
Home screens for other units and other Xanbus-enabled devices in the system.
Figure 2-7 Conext XW+ Home Screen
setup system
XW+ 6848 00:Home
Invert
-26.4A 51.9V
1250W
0.0V 0W
Top Line: Device name and number
Line 1: Conext XW+ status
Line 2: Battery current (in + or out -) and voltage
(Battery current is negative when selling.
Amps * Volts = Total Power Sold)
Setup arrow indicates the Enter button.
Pressing Enter displays the Conext XW+
setup menu.
System arrow indicates the Exit
button. Pressing Exit displays the
System Home screen.
Line 3: Power supplied to loads
Line 4: AC in status
Table 2-1 Conext XW+ Home Screen States
Conext XW+
Status
Displayed When...
Invert The Conext XW+ is supplying power to loads on AC OUT by inverting power from the
batteries. AC input from the utility (AC1) or generator (AC2) is absent or out of nominal
range.
Qualifying
AC
The Conext XW+ is determining if AC input on AC1 or AC2 is within a usable voltage
and frequency range. Qualifying AC is also displayed when the Conext XW+ is
awaiting application of AC power or a command to enable invert mode.
Charging The Conext XW+ is charging the batteries from qualified AC input from the utility grid
(AC1) or a generator (AC2). The charge state is in transition to either bulk, absorption,
float, or equalize. AC input is also passed through to the load while charging.
Bulk The Conext XW+ is bulk charging the batteries from qualified AC input from the utility
grid (AC1) or a generator (AC2). AC input is also passed through to the load while bulk
charging.
Absorption The Conext XW+ is absorption charging the batteries from qualified AC input from the
utility grid (AC1) or a generator (AC2). AC input is also passed through to the load
while absorption charging.
ABS Finish The Conext XW+ has completed the absorption stage and is waiting for other Conext
XW+ units in the system to complete absorption. This status can occur only when there
is another Conext XW+ also charging the battery.
Float The Conext XW+ is float charging the batteries from qualified AC input from the utility
grid (AC1) or a generator (AC2). The Conext XW+ is set for three-stage charging. AC
input is also passed through to the load while float charging.
Conext XW+ Owner's Guide NA (975-0240-01-01).book Page 15 Monday, November 27, 2017 10:00 AM