Schneider Electric User Guide

Configuration

3–2 975-0240-01-01

Using the Conext System Control Panel

The Conext XW+ is configured using the Conext SCP (Conext System Control

Panel). The Conext SCP provides access to settings relating to AC input and

output, battery charging, and grid-tie operation.

Conext XW+ Setup Menu

The Conext XW+

Setup

menu is accessible either from the system

Home

screen or

from the Conext XW+

Home

screen.

To navigate to the Conext XW+ Setup menu:

1. From the system Home screen, press Enter to view the Select Device menu.

Or from the Conext XW+ Home screen, press Enter. The Conext XW+ Setup

menu appears. Go to step 2.

2. Highlight the Conext XW+ device name, then press Enter.

NOTICE

EQUIPMENT DAMAGE

Any configuration (change in settings) made when the Conext XW+ 6848 NA

is in Operating mode will not be saved unless the Conext XW+ 6848 NA is put

in Standby and then back to Operating mode. It is recommended to put the

Conext XW+ 6848 NA in Standby mode prior to changing basic or advanced

settings. Then return to Operating mode for the settings to take effect.

Failure to follow these instructions can damage equipment.

Figure 3-1 Conext XW+ Setup Menu

Table 3-1 Conext XW+ Setup Menu

Menu Item Description

Meters Displays the Meters screen.

XW+ 6848 00: Setup

Meters

[Enabled]

[Disabled]

[Enabled]

[None]

[Disabled]

[Operating]

Note: The Conext SCP only displays

four lines of the Setup menu at once. To

view additional settings, press the Down

arrow button.

Conext XW+ Owner's Guide NA (975-0240-01-01).book Page 2 Monday, November 27, 2017 10:00 AM