Schneider Electric User Guide

Using the Setup Menus
975-0240-01-01 3–5
To select the Advanced settings:
1. On the Select Device menu, select a Conext XW+.
2. Press and release Enter + up arrow + down arrow at the same time.
The Conext XW+ advanced settings include menus for configuring:
• Inverter settings (see page 3–8)
• Charger settings (see page 3–11)
• AC transfer limit settings (see page 3–24)
• Grid support and peak load shaving settings (see page 3–26)
• Generator support settings (see page 3–34)
• Auxiliary output settings (see page 3–37).
• Multi-unit operation, including customizing the default model name of the
Conext XW+ and setting its network device number. Setting the device
number is important when multiple Conext XW+ units are on the Xanbus
network and sharing connections such as AC loads, utility grid, and
generator. The device number is also used when configuring paralleled
Conext XW+ units for master-slave operation (see “Inverter Settings Menu”
on page 3–8).
In the advanced settings you can also copy another unit’s settings using the Copy
from command.
To view the advanced or basic settings:
•From the Setup menu, with Basic Settings or Advanced Settings
highlighted, press Enter. See Figure 3-2.
Notes:
• This keypress enables the advanced settings for every device in the system.
• After performing the keypress, Advanced Settings appears at the top of the
Setup menu. When the keypress is performed again, the Setup menu
displays Basic Settings as the last item on the menu.
•See NOTICE in the beginning of this section.
Figure 3-2 Selecting Advanced Settings
XW+ 6848 00: Adv
Inverter Settings
[XW+ 6848 01]
XW+ 6848 00: Setup
Advanced Settings
[Enabled]
[Disabled]
[Disabled]
[Enabled]
[None]
[Disabled]
[Operating]
Conext XW+ Owner's Guide NA (975-0240-01-01).book Page 5 Monday, November 27, 2017 10:00 AM