Schneider Electric User Guide

Copying Settings From Another Unit
975-0240-01-01 3–47
Copying Settings From Another Unit
The Copy from command allows quick configuration of a Conext XW+. After
selecting another Conext XW+ in the system to copy settings from, common
parameters are copied from the selected Conext XW+ to the Conext XW+ being
configured.
The following settings are copied from the selected unit:
• Inverter settings
• Charger settings
• AC settings
• Grid support settings (except the Sell setting)
• Gen support settings
The following settings are not copied between units:
• Inverter mode
• Device number
• Device name
• Auxiliary output settings
Copying Settings in
Multi-Cluster
This XW+ Advanced Setting does not apply in a Xanbus network with more than
three XW+ units.
Cascading in SCP
System Settings
This System Setting in the SCP does not apply in Multi-Cluster Configuration with
different DC Associations, meaning each cluster has its own battery bank while
the XW+ units are connected under a single Xanbus network. Set Cascading =
Disabled.
WARNING
ADVANCED CONFIGURATION HAZARD
Advanced menu settings should be used by qualified personnel only.
Three phase operation should be configured by qualified personnel only.
Consult with the local utility before enabling Conext XW+ sell mode or grid
support functions.
Do not change these settings unless you are under the supervision and
direction of qualified personnel.
Failure to follow these instructions can result in death or serious injury.
Conext XW+ Owner's Guide NA (975-0240-01-01).book Page 47 Monday, November 27, 2017 10:00 AM