Schneider Electric User Guide

Configuration
3–48 975-0240-01-01
Resetting the Conext XW+ to Default Settings
The Restore Defaults command returns the Conext XW+ to factory default
settings. After using the Restore Defaults command, the Conext XW+ is no
longer configured for the power system.
To restore Conext XW+ default settings:
1. On the Advanced Setup menu, select Restore Defaults.
Warning W252 appears, asking to confirm the command.
2. To cancel the command, press Exit. To continue with the Restore Defaults
command, press Enter.
WARNING
ADVANCED CONFIGURATION HAZARD
Advanced menu settings should be used by qualified personnel only.
Three phase operation should be configured by qualified personnel only.
Consult with the local utility before enabling Conext XW+ sell mode or grid
support functions.
Do not change these settings unless you are under the supervision and
direction of qualified personnel.
Failure to follow these instructions can result in death or serious injury.
NOTICE
RESTORING DEFAULTS
Do not restore defaults while the Conext XW+ is operating. De-energize the
power system and disconnect the Conext XW+ AC input before restoring
defaults. Reconfigure the Conext XW+ before reconnecting the AC input and
re-energizing the power system.
Failure to follow these instructions can result in equipment damage.
Note: If a warning is already active in the system, selecting Restore Defaults
brings up the Warnings list, with warning W252 at the top. Press Enter to view
W252 and continue with the restore defaults process.
Conext XW+ Owner's Guide NA (975-0240-01-01).book Page 48 Monday, November 27, 2017 10:00 AM