Conext XW Pro Installation Guide

Knockout Selection
Note: Do not drill, cut, or punch holes into the Conext XW Pro, Conduit Box or Power
Distribution Panel (PDP). Use only the knockouts provided for conduit entry.
The Conext XW Pro, Power Distribution Panel (PDP), and Conduit Box are equipped
with nested dual knockouts for wiring through conduits.
Read "Removing the AC Access Panel and PDP Internal Faceplates" on page44 and
choose the knockouts for your installation.
See below, for an example of available knockouts along the top and side of the Power
Distribution Panel (PDP).
Figure 11 Example of available knockouts on the PDP
Remove your choice of knockouts from the Conext XW Pro chassis, Conduit Box,
and/or Power Distribution Panel (PDP). Verify that no debris remains inside the chassis.
Insert appropriately-sized conduit bushings into each conduit hole.
Pre-Installation Planning Conext XW Pro Installation Guide
990-91228A-01 This manual is intended for use by qualified personnel 28