Conext XW Pro Installation Guide
Figure 14Mounting plate centered on wall studs
Installation tip
If you install the bottom of the mounting plate at 60" from floor, the inverter information
panel will be approximately 65" from the floor.
4. Install additional mounting plates adjacent to each other as needed.
Note: The mounting plates are designed to interlock, as shown in the figure below, so
that multiple plates can be installed without additional measuring or leveling.
Figure 15 Two interlocking mounting plates
Wall-Mounting the Conext XW Pro and PDP
To wall-mount the Conext XW Pro Inverter/Charger:
1. Align the flange on the back of the Conext XW Pro chassis with the bottom edge of
the mounting plate, as shown in Figure 16 .
Pre-Installation Planning Conext XW Pro Installation Guide
990-91228A-01 This manual is intended for use by qualified personnel 32