Conext XW Pro Installation Guide

Installing the XW Conduit Box
The Conduit Box is divided into two parts: the rear panel and the front panel.
To secure the Conduit Box to the Conext XW Pro chassis:
1. Remove both #10 screws from the bottom of the Conext XW Pro chassis.
2. Find the keyhole slots located under the top of the rear panel.
3. Align the keyhole slots on the top panel of the Conduit Box with the corresponding
#10 screws on the bottom of the inverter.
Figure 17 Conduit Box keyhole alignment
4. Secure the Conduit Box to the inverter with the both #10 screws.
5. Using two screws (not included), secure the bracket at the bottom edge of the rear
panel to the wall. See Figure 18 .
Figure 18 Wall-mounting the Conduit Box
Installation tip
Do not secure the front panel of the Conduit Box until you have completed all wiring.
Pre-Installation Planning Conext XW Pro Installation Guide
990-91228A-01 This manual is intended for use by qualified personnel 34