Conext XW Pro Installation Guide

Communications Network Preparation
WARNING
XANBUS SHOCK HAZARD
Xanbus cables in contact with DC or AC power can transmit an electric shock. Do not route
the Xanbus cables in the same conduit or panel as the AC and DC power cabling.
Failure to follow these instructions can result in death, serious injury, or equipment
damage.
To separate the communications cables and signal cables from the DC and AC wiring, a
raceway (wire barrier) has been included in the design of both the Power Distribution
Panel (PDP) and the Conduit Box.
This raceway is built into the bottom of the Power Distribution Panel (PDP) and Conduit
Box (see Figure 20 , below) and is held in place by a single screw at the top of each
raceway.
Figure 20 Example of raceways in a single-inverter system
Before making AC and DC connections, route communication cables (including Battery
Temperature Sensor) through the raceways. For easier identification, use a different color
for each communications cable, or cable tags.
Connect communications cables to their components after AC and DC connections are
made.
Pre-Installation Planning Conext XW Pro Installation Guide
990-91228A-01 This manual is intended for use by qualified personnel 36