Conext XW Pro Installation Guide
To remove the AC access panel, remove the two screws from the AC access cover and
slide the cover slightly to the left and lift away from the Conext XW Pro chassis.
Installation tip
When re-securing the AC access cover, verify that its recessed edge slips inside the
edge of the front panel.
Figure 21AC access panel removal
Removing Power Distribution Panel Internal Faceplate
If you are wiring the Conext XW Pro to a Power Distribution Panel (PDP), you will need
to remove the two front faceplates from the PDP.
For easier access to the faceplates, begin by removing the panel door from its hinges.
To remove the PDP door:
1. Remove the screw at the top hinge of the PDP door and remove the top section of the
hinge.
2. Using your thumb or forefinger, gently pivot the hinge upward as you remove the PDP
door.
To remove the PDP faceplates:
1. Remove the four screws holding the upper faceplate in place.
2. Remove the four screws holding the lower faceplate in place.
Conext XW Pro Installation Guide Wiring
45 This manual is intended for use by qualified personnel 990-91228A-01