Conext XW Pro Installation Guide

DANGER

HAZARD OF ELECTRIC SHOCK, EXPLOSION, ARC FLASH, AND FIRE

n Remove watches, rings, or other metal objects.

n This equipment must only be installed and serviced by qualified electrical personnel.

n Keep sparks and flames away from the batteries.

n Use tools with insulated handles.

n Wear protective glasses, gloves and boots.

n Do not lay tools or other metal parts on top of batteries.

Failure to follow these instructions will result in death or serious injury.

DANGER

HAZARD OF ELECTRIC SHOCK, EXPLOSION, ARC FLASH, AND FIRE

n Battery Circuit Breakers must be installed according to the specifications and

requirements defined by Schneider Electric.

n Servicing of batteries must only be performed by qualified personnel knowledgeable of

batteries and the required precautions. Keep unqualified personnel away from

batteries.

n Disconnect the charging source prior to connecting or disconnecting battery terminals.

Failure to follow these instructions will result in death or serious injury.

To access the AC terminal block, you will need to remove the AC access panel. For

more information, see "Removing the AC Access Panel and PDP Internal Faceplates"

on page44.

The AC terminal block includes three terminals each (L1, L2, and Neutral) for AC Grid

input (AC1), AC Generator input (AC2), and AC Out (AC LOAD) connections, see Figure

30.

Figure 30AC Terminal Block

AC INAC OUT AC IN

GRID

(AC1)

LOAD

GEN

(AC2)

NL1L2NL1L2NL1 L2