Conext XW Pro Installation Guide

DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, ARC FLASH, AND FIRE
n Remove watches, rings, or other metal objects.
n This equipment must only be installed and serviced by qualified electrical personnel.
n Keep sparks and flames away from the batteries.
n Use tools with insulated handles.
n Wear protective glasses, gloves and boots.
n Do not lay tools or other metal parts on top of batteries.
Failure to follow these instructions will result in death or serious injury.
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, ARC FLASH, AND FIRE
n Battery Circuit Breakers must be installed according to the specifications and
requirements defined by Schneider Electric.
n Servicing of batteries must only be performed by qualified personnel knowledgeable of
batteries and the required precautions. Keep unqualified personnel away from
batteries.
n Disconnect the charging source prior to connecting or disconnecting battery terminals.
Failure to follow these instructions will result in death or serious injury.
Before installing additional Conext XW Pro units, disconnect all power from the system.
Depending on your installation, you may need to perform the following pre-installation
steps:
1. Wall-mount additional Conext XW Pro(s), as needed. See Wall-Mounting the Conext
XW Pro and PDP on page 32.
2. Install Conduit Box as needed. See Installing the XW Conduit Box on page 34.
3. Prepare the communications network. See See "Installing AC sync and Xanbus
cables" on page102.
4. Install a Conext Gateway to configure programmable settings and to name specific
network components, as needed. See Conext Gateway Installation on page 107.
Note: When installing more than one Conext XW Pro at a location, use a Conext
Gateway to give a unique Device Number to each Conext XW Pro. This will help
ensure Master/Slave relationships and other relevant configurations match the
planned setup.
Up to three Conext XW Pro units can be connected to a PDP in a split-phase system. To
connect two Conext XW Pro units to a PDP, see "Installing a Dual Inverter/Charger
System" on the facing page. To connect three Conext XW Pros to a PDP, see "Installing
a Triple Inverter/Charger System" on page81.
Conext XW Pro Installation Guide Wiring
75 This manual is intended for use by qualified personnel 990-91228A-01