Conext XW Pro Installation Guide

20. Confirm both inverters start charging.
Depending on the battery bank’s state-of-charge, the output from one or more
inverters may quickly drop to zero. This is considered normal operation.
21. Check for events. If events exist, correct, and then restart the FunctionalTest.
If the Inverters pass the Functional Test, proceed to the Commissioning procedure as
defined in the Owner's Guide.
Wiring the Conext XW Pro Inverter/Charger without a PDP
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, ARC FLASH, AND FIRE
n Apply appropriate personal protective equipment (PPE) and follow safe electrical work
practices. See NFPA 70E or CSA Z462.
n This equipment must only be installed and serviced by qualified electrical personnel.
n Never operate energized with covers removed
n Energized from multiple sources. Before removing covers identify all sources, de-
energize, lock-out, and tag-out and wait 5 minutes for circuits to discharge
n Always use a properly rated voltage sensing device to confirm all circuits are de-
energized.
Failure to follow these instructions will result in death or serious injury.
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, ARC FLASH, AND FIRE
n Remove watches, rings, or other metal objects.
n This equipment must only be installed and serviced by qualified electrical personnel.
n Keep sparks and flames away from the batteries.
n Use tools with insulated handles.
n Wear protective glasses, gloves and boots.
n Do not lay tools or other metal parts on top of batteries.
Failure to follow these instructions will result in death or serious injury.
Conext XW Pro Installation Guide Wiring
89 This manual is intended for use by qualified personnel 990-91228A-01