Conext XW+ 230V Installation Guide

Conext XW+ Inverter/Charger Accessories Installation
5–6 975-0714-01-01
This manual is for use by qualified personnel only
3. For easier access, remove the right-side panel of the Conext XW+, as shown
in Figure 5-3.
4. Carefully remove the inverter information panel from the Conext XW+
chassis, and detach it from the inverter communication cable.
5. Remove the metal support plate from the housing of the Conext XW+
chassis.
6. Unplug the communication cable from the upper communication port
To install the SCP into the Conext XW+ chassis:
1. Plug the inverter communication cable into the lower communication port
2. Carefully place the SCP into the housing of the Conext XW+ chassis.
Figure 5-3 Right-side panel removal
(Internal components
hidden for clarity.)